Viewed products
The Spiderbeam Heavy Duty 12m fibreglass mast...
The Spiderbeam Heavy Duty 12m fibreglass mast is the right choice for using a wide variety of 40/80/160m long wire and GP or inverted L antennas, lightweight 1-element Quad or Delta loops for 20-10m, as well as dipoles for all HF and VHF-UHF bands, this mast can support small VHF/UHF yagis at a height of 9-10m.
This 12m telescopic mast can be erected in minutes by one person and has been specifically designed for the robustness and durability needs of portable equipment. It measures 118cm fully folded.
It has a much greater wall thickness, 2mm at its thickest, than the usual "fishing rod".
It can be used with AWG 18 (= 1mm diameter) enamelled copper wire or similar to build vertical antennas, loops, dipoles, etc.
Supplied with: 1 Spiderbeam 12m.
* Due to production variations, the dimensions shown may vary slightly. This does not affect quality or performance.
Unlike the poles offered by most competitors, the top segment of the Spiderbeam is not a very thin and fragile whip. Instead, the mast can be used over its full 7m length, offering great flexibility and optimal height utilisation.
It uses a special reinforcement winding technique, where several layers of fibreglass are wound in an alternating direction (cross-wound), which considerably increases their lateral and linear strength.
The joints between the individual tube segments are also strengthened by a larger than usual overlap.
Unlike other poles where the top segment is very thin like a whip, the top segment of the Spiderbeam Heavy Duty poles has a diameter of 8mm (and a wall thickness of 1.4mm), which allows them to be used over their entire 12m length.
Reference: SPIDERBEAM-ASG12-18M-2164
Ultra-strong guy rope for Spiderbeam 12m telescopic mast, with attachment points for 3 or 4 guy ropes, allowing 90° or 120° orientation and attachment of the guy ropes to ground stakes approximately 5
Reference: CORDON-RG58-BNC-30CM-1115
Coaxial patch cable with BNC Male connector - BNC Male with RG58 MIL-C-17 50 ohm coaxial cable for use in frequencies from 0 to 1000Mhz. Available in different lengths: 30cm, 50cm, 1m or 2 metres
Reference: MASTRANT-COSSE-ATH03-1885
The core lug protects the guy at the end against premature wear, fraying and is indispensable for guying. Made of A4 stainless steel (AISI 316) to prevent rusting. Also suitable for steel guy wire.
Reference: MASTRANT-CLIP-ADC03-1911
Cable clamp (duplex clip) prevents spontaneous loosening, strong counter-pressure due to the elasticity of the ropes. The 2 nuts allow for easy loosening for adjustments. To be used with a heart lug
Reference: SIGMA-G5RV-DEMI-406
Invented by G5RV amateur, R. Louis VARNEY published for the first time the technical documentation of its antenna in November 1966. The G5RV wire antenna have 2 versions: 1/2 half size, about 16
Reference: DIAMOND-BU50A-517
Diamond BU50/A balun 1:1, genuine, operates from 1.7 to 40Mhz and allows to receive and transmit on HF bands.Technical data sheet of the HF BU50A balun:● Operating frequency from 1.7 to 40MHz●
Reference: MESSI-JUMPER-UF7-5UM-UM-1446
Messi & Paoloni coaxial cable ready to use with UHF male connector (PL male), with a diameter of 7mm with M&P ULTRAFLEX 7 cable, very flexible and offering excellent performance with lower
40,90 €
Reference: MESSI-JUMPER-M-HYF5-1UM-1145_5
This coaxial cable extension is ready to use, with UHF Male connector (PL-259) Messi & Paoloni, with a diameter of 5.4mm with M&P HYPERFLEX 5 cable, hyper flexible and very light and offering
Click here to leave a review
Be the first to ask a question about this product!
Invented by G5RV amateur, R. Louis VARNEY published for the first time the technical documentation of its antenna in November 1966. The G5RV wire antenna have 2 versions: 1/2 half size, about 16
40,83 €tax excl.
Diamond BU50/A balun 1:1, genuine, operates from 1.7 to 40Mhz and allows to receive and transmit on HF bands.Technical data sheet of the HF BU50A balun:● Operating frequency from 1.7 to 40MHz●
30,69 €tax excl.
This coaxial cable extension is ready to use, with UHF Male connector (PL-259) Messi & Paoloni, with a diameter of 5.4mm with M&P HYPERFLEX 5 cable, hyper flexible and very light and offering
27,42 €tax excl.
Messi & Paoloni coaxial cable ready to use with UHF male connector (PL male), with a diameter of 7mm with M&P ULTRAFLEX 7 cable, very flexible and offering excellent performance with lower
34,08 €tax excl.
The EMCOMM III Portable antenna from Chameleon is a portable antenna from 1.8 to 30 MHz, specially designed for short to long range HF communications (DX). It is suitable for amateur radio bands and
156,67 €tax excl.
235,00 € -20%The AS603 tripod is designed for the DAP-450 and DAP-600 masts. The holder is equipped with an adapter ring, so that the two masts with different diameters are held securely. Other masts can be used
165,83 €tax excl.
Diamond DAP-450 telescopic pole in 4 sections with diameters from 34 to 22mm, for a minimum height of 1.4m to a maximum of 4.5m, full extension. High strength anodised aluminium construction, complete
124,17 €tax excl.
Diamond DAP-600 telescopic pole in 5 sections with diameters from 42 to 26mm, for a minimum height of 1.5m to a maximum of 6m, full extension. High strength anodised aluminium construction, complete
182,50 €tax excl.
The CHA Pocket OFCD is a 40m - 6m (7 to 54 MHz) multi-band HF antenna, WINDOM type, asymmetric dipole OCF (off-center-fed) and can fit in a pocket when not in use. This antenna is designed for
This 7m telescopic pole from Spiderbeam is a lightweight pole that is easy to carry and can be set up quickly. Although compact and easy to store in any large suitcase (71cm folded), this telescopic
54,17 €tax excl.
69,00 €The Spiderbeam 10m Telescopic Pole is the ideal solution for users looking for a lightweight, easy to carry pole that can be set up quickly and easily. Compact and easy to store in any large suitcase
70,83 €tax excl.
The M0CVO HW-20HP is an OFCD type dipole antenna that incorporates the M0CVO 4:1 balun at the feed point, allowing direct feeding with 50 ohm coaxial cable. At only 10.14 metres in length, it can be
64,35 €tax excl.
The M0CVO HW-40HP is a dipole antenna that incorporates the M0CVO 4:1 balun at the feed point, allowing direct feeding with 50 ohm coaxial cable. The M0CVO HW-40HP is just 20.28m long, and can be
66,02 €tax excl.
The M0CVO high power 1:1 Balun operates from 1.8 to 30MHz. It can handle up to 400W PEP (CW or SSB). It is used to match a balanced antenna, such as a dipole, to an unbalanced feed such as coaxial
38,25 €tax excl.
The M0CVO high power 4:1 Balun operates from 1.8 to 54MHz. It supports up to 400W CW or 500W PEP in SSB. It is used to convert the 200Ω impedance seen at the feed point of a bent or off-centre fed
38,25 €tax excl.
MASTRANT-P2 is a 1.6mm rope with a strength of 100 daN / kg, specially designed for guy ropes, offering an excellent price-performance ratio. This high quality rope has outstanding strength, low
14,88 €tax excl.
This tripod is a mobile support for satellite dishes from 60 cm to 80 cm in diameter. The mast is adjustable up to 120 cm in height, and can be swivelled in all directions. Made from lightweight,
37,63 €tax excl.
MASTRANT-P3 is a 2.6mm rope with a strength of 200 daN/kg, specially designed for guy ropes, offering an excellent price-performance ratio. This high quality rope has outstanding strength, low
21,49 €tax excl.
MASTRANT-P3+ is a 1.6mm rope with a strength of 300 daN/kg. This high quality rope has outstanding strength, low stretch, excellent UV and moisture resistance. It is lightweight, extremely abrasion
28,93 €tax excl.
MASTRANT-P4 is a 4.4mm rope with a strength of 440 daN/kg and is available in neon blue and black. This high quality rope has outstanding strength, low stretch, excellent UV and moisture resistance.
34,71 €tax excl.
Stock and shipped from France
14 days to return, 2 warranty
Response within 24h to 72h
SSL, VISA, Mastercard, Paypal
Copyright 2014-2024 - Passion Radio / 4 MY PEOPLE.
Les photos et coloris ne sont pas contractuels.