Equipement from manufacturer OPA Design

• 

  63,32 €

  Reference: OPA-ANT-FIXE2-ADSB-1042

  1090 Mhz ADS-B 5dBi Fixed antenna OPA Design

  Fixed vertical fiberglass antenna for ADS-B 1090 Mhz reception, for use as an outdoor pole, with mounting bracket included and female N antenna connector.This ADS-B antenna consists of a half-wave

  63,32 €
• 

  52,50 €

  Reference: OPA-ANT-FIXE-868-V2-N-1568

  868 MHz 4.4dBi tuned antenna for ISM 868 LoRa Helium Meshtastic network

  This antenna is specially designed to improve the performance of ISB band 868 MHz devices.It is tuned for 868 MHz frequencies, with a SWR of less than 1.2, which allows it to use almost the entire

  52,50 €
• 

  40,94 €

  Reference: QO100-F1OPA-AMPLI2400-938

  RF Amplifier 2400 MHz 100mW for QO-100 and Upconverter F1OPA

  This power amplifier equipment with a gain of 30dB is intended to operate primarily with F1OPA's upconverter 144 / 432Mhz - 2400 MHz to traffic on the QO-100 satellite uplink with 100mW output (20dBm)

  40,94 €

  40,94 €

  Online only
• 

  31,50 €

  Reference: F1OPA-WIDEBAND-LNA3-805

  LNA Wide Band 50-2500Mhz amplifier F1OPA

  Wide-band LNA preamp, based on PGA-103+, to improve reception performance from 50 Mhz to 1500 Mhz, with a maximum gain of 20-24dB and a noise factor of 0.4dB.This VHF-UHF LNA offers a very good

  31,50 €

  Online only
• 

  29,58 €

  Reference: OPA-LNAHF-HFLNA-284

  LNA preamplifier for HF SDR 500 kHz to 30 MHz from F1OPA

  The LNA HF from F1OPA is a pre-amplifier and a low-pass filter (LNA), very powerful (+18dB to +20dB), with SMA Female connectors, for HF frequencies and short waves from 500 kHz to 30 MHz, with

  29,58 €

  29,58 €

  Online only
• 

  23,25 €

  Reference: FILTRE-SAW1-ADSB-OPA-804

  1090 Mhz SAW Bandpass ADS-B filter F1OPA

  This ADS-B bandpass/cut filter for 1090Mhz allows to improve the performance and the selectivity of the signal in ADS-B reception and to suppress the signals outside the 1090Mhz band.Delivered with :

  23,25 €

  Online only
• 

  23,25 €

  Reference: FILTRE-SAW2-868-F1OPA-830

  Bandpass SAW Filter 868 Mhz for Helium LoRa Meshtastic Lorawan SigFox Zigbee

  This filter for the 868 MHz bandpass allows to improve the selectivity of the reception and to suppress the parasitic signals outside the 868MHz band and in particular to reject the GSM 900 MHz

  23,25 €

  Online only
• 

  22,42 €

  Reference: FILTRE-SAW-QO100-F1OPA-824

  2.4 Ghz SAW Bandpass filter for QO100

  This bandpass filter for the 2.4 Ghz (13cm) allows to reject the local oscillator and harmonics frequencies of the Up-Converter for QO-100 to get a clean signal on the satellite, with a max. input

  22,42 €

  Online only
• 

  16,58 €

  Reference: OPA-BOITIER-941

  Half aluminium case for PCB OPA Design

  This milled half aluminum box is specially designed for the RF protection of PCB's from F1OPA Design: LNA VHF-UHF, Bias-T, 2.4Ghz amplifier, SAW 868Mhz filters, ADS-B, QO-100 2.4Ghz and HF LNA.Case

  16,58 €

  16,58 €

  Online only
• 

  14,58 €

  Reference: QO100-OPA-BIAS-T1-760

  BIAS-TEE for QO-100 or LNA 30MHz to 4GHz F1OPA

  This BT4G-based BIAS-TEE with SMA female connector is used to power a LNA or a 10Ghz PLL LNB to receive the QO-100 / Es'Hail2 satellite.The BT4G covers the frequency bands from 30 MHz to 4 GHz. The

  14,58 €

  14,58 €

  Online only