No products
New products
-
LILYGO T-BEAM SUPREME SX1262 433 MHz Meshtastic LoRa WiFi BT5 GPS
55,78 € tax excl. -
TTGO T-BEAM SUPREME SX1262 Meshtastic 868 MHz Lora WiFi BT5 GPS
55,78 € tax excl. -
Diamond HVC14CX 20m & 30m coil for HV7CX antenna
27,40 € tax excl. -
Diamond HV7CX multiband mobile HF VHF & UHF antenna
152,78 € tax excl.
Viewed products
-
Nooelec RF Shield Kit...
This RF shield Nooelec and component kit is...
-
Power charger Baofeng for Anytone D868 & D878
7,19 € -3% 7,42 €
-3%
View larger 
Online only
Nooelec RF Shield Kit for HackRF One
Read the reviewThis RF shield Nooelec and component kit is specifically designed for HackRF One to eliminates EMI nearby.
Comes with: RF shield, shield frame, shield cover, GND clip testpoint, J10, and a 20 position female header for P30 (BANK2_AUX).
Delivered with: Nooelec official shield kit (Armature with metal cover, 20-position female connector).
This kit requires soldering basic skills.
Data sheet
This kit requires basic soldering skills. Though these components are 'easy' to solder we don't recommend learning on your brand new HackRF!
The plastic enclosure included with HackRF slightly impedes the RF shield footprint area.
This can be rectified through minor modification of the plastic case, which can be done with a sharp hobby knife and a few minutes of time.
This kit contains the unpopulated RF shield for HackRF to help reduce stray EMI. The shield frame needs to be soldered to the board, and the shield cover mounts atop the frame.
Also included is the GND clip testpoint, J10, and a 20 position female header for P30 (BANK2_AUX).
Customers also bought
257,86 € 265,83 € tax excl. -3%tax excl. In stock-3%
Reference: GSG-HACKRF-BOITE-75
HackRF One SDR Transceiver TX RX 1-6000MHz - RF development board - Genuine Version
The HackRF One is a SDR receiver-transmitter covering from 1MHz to 6GHz in all available modes, analog and digital.Tip: For use in the lab, or with strong signals nearby, the sensitivity of the device
257,86 €265,83 €
Reduced price!
30,64 € 31,58 € tax excl. -3%tax excl. In stock-3%
Reference: NOO-999014-BOITIER2-HACKRF-327
Aluminium case HackRF One - Nooelec
Nooelec aluminium case V2 (new version) specifically designed for HackRF One reduce parasitic interference nearby and add a stronger resistant case. This aluminum case is for replacing the original
30,64 €31,58 €
Online only Reduced price!
25,25 € 26,03 € tax excl. -3%tax excl. In stock-3%
Reference: NOOELEC-100773-TCXO-HACKRF-719
Nooelec Module Tiny TCXO 10Mhz for HackRF
This ultra-flat 10 MHz Tiny TCXO module is for HackRF One. This 0.5 ppm TCXO improves performance with ultra-low phase noise and high frequency stability in almost any condition.Perfect for any high
25,25 €26,03 €
Reduced price!
28,21 € 29,08 € tax excl. -3%tax excl. In stock-3%
Reference: GSG-HACKRF-ANT500-74
ANT500 SDR ADSB antenna 75-1000Mhz SMA-M
Telescopic antenna ANT500, VHF-UHF 50 ohms designed to operate in RX from 75 MHz to 1 GHz. Configurable length of 20 cm to 88 cm. Stainless steel SMA male connector and elbow swivel 360 °. This is an
28,21 €29,08 €
Online only Reduced price!
We also recommend
- 28,21 € 29,08 € tax excl. -3%tax excl. In stock
-3%
Reference: GSG-HACKRF-ANT500-74
ANT500 SDR ADSB antenna 75-1000Mhz SMA-M
Telescopic antenna ANT500, VHF-UHF 50 ohms designed to operate in RX from 75 MHz to 1 GHz. Configurable length of 20 cm to 88 cm. Stainless steel SMA male connector and elbow swivel 360 °. This is an
28,21 €29,08 €
Online only Reduced price! 
40,34 € 41,58 € tax excl. -3%tax excl. In stock-3%
Reference: DIAMOND-MCRMSMA-142
Magnet SMA base bracket
Diamond MCRMSMA is a magnet base bracket for handheld transceivers and any devices with SMA connector. Coaxial cable: RG58 2.5m Connector: SMA Male / SMA FemaleMagnet diameter: 53mm
40,34 €41,58 €
Reduced price!
26,59 € 27,42 € tax excl. -3%tax excl. In stock-3%
Reference: DIAMOND-SRH789-259
Diamond antenna SRH-789 SMA-M 95-1100Mz + TX 144/430Mhz
Dual band directional antenna Original Diamond SRH-789 with SMA Male connector, for receiving and transmitting on VHF-UHF bands (144/430 MHz) and reception on aviation bands 120/150/300/450/800 MHz
26,59 €27,42 €
Reduced price!
29,58 €Reference: OPA-LNAHF-HFLNA-284
LNA preamplifier for HF SDR 500 kHz to 30 MHz from F1OPA
The LNA HF from F1OPA is a pre-amplifier and a low-pass filter (LNA), very powerful (+18dB to +20dB), with SMA Female connectors, for HF frequencies and short waves from 500 kHz to 30 MHz, with
29,58 €29,58 €
Online only
Reviews
Une nervure du boîtier plastique d'origine doit être supprimée pour permettre le ré-assemblage.
Additional or similar equipment
-
ANT500 SDR ADSB antenna 75-1000Mhz SMA-M
Telescopic antenna ANT500, VHF-UHF 50 ohms designed to operate in RX from 75 MHz to 1 GHz. Configurable length of 20 cm to 88 cm. Stainless steel SMA male connector and elbow swivel 360 °. This is an
28,21 € tax incl.In stock28,21 €tax excl.
29,08 € -3% -
Magnet SMA base bracket
Diamond MCRMSMA is a magnet base bracket for handheld transceivers and any devices with SMA connector. Coaxial cable: RG58 2.5m Connector: SMA Male / SMA FemaleMagnet diameter: 53mm
40,34 € tax incl.In stock40,34 €tax excl.
41,58 € -3% -
Diamond antenna SRH-789 SMA-M 95-1100Mz + TX 144/430Mhz
Dual band directional antenna Original Diamond SRH-789 with SMA Male connector, for receiving and transmitting on VHF-UHF bands (144/430 MHz) and reception on aviation bands 120/150/300/450/800 MHz
26,59 € tax incl.In stock26,59 €tax excl.
27,42 € -3% -
LNA preamplifier for HF SDR 500 kHz to 30 MHz from F1OPA
The LNA HF from F1OPA is a pre-amplifier and a low-pass filter (LNA), very powerful (+18dB to +20dB), with SMA Female connectors, for HF frequencies and short waves from 500 kHz to 30 MHz, with
29,58 € tax incl.In stock29,58 €tax excl.
LNA VHF UHF preamplifier with PGA-103 + for RF and SDR application
The LNA4ALL is a pre-amplifier and a low-pass filter (LNA) with SMA female RF connectors and for RF frequencies covering all bands from 28MHZ to 2500 MHz. It improves greatly reception performance, on
37,42 € tax incl.In stock37,42 €tax excl.
USB VFO jog Shuttle Xpress Contour Design for SDR
Allows to control by USB the change of frequencies of an SDR software and to get a classic operation of a VFO on a radio hardware SDR!Fully configurable with the supplied software, Shuttle Xpress is
-
Aluminium case HackRF One - Nooelec
Nooelec aluminium case V2 (new version) specifically designed for HackRF One reduce parasitic interference nearby and add a stronger resistant case. This aluminum case is for replacing the original
30,64 € tax incl.In stock30,64 €tax excl.
31,58 € -3% 
Antenna ANT700 300-1100Mhz SDR VHF UHF ADSB
Telescopic Antenna ANT700 from 300 to 1100 MHz, made by Great Scott Gadgets. The total length of the antenna ANT700 is configurable from 9.5 cm to 24.5 cm. The ANT700 is constructed of stainless
23,36 € tax incl.In stock23,36 €tax excl.
24,08 € -3%-
Nooelec Module Tiny TCXO 10Mhz for HackRF
This ultra-flat 10 MHz Tiny TCXO module is for HackRF One. This 0.5 ppm TCXO improves performance with ultra-low phase noise and high frequency stability in almost any condition.Perfect for any high
25,25 € tax incl.In stock25,25 €tax excl.
26,03 € -3% Opera Cake 8 port automatic antenna switch for HackRF One
Opera Cake is an additional antenna switch card for the HackRF One SDR development board.This antenna switch can be configured with command line software for automatic port switching based on
165,84 € tax incl.Out of stock, available within 1-2 months165,84 €tax excl.
174,17 €
Delivery Europe & Overseas
Stock and shipped from France
Product return
14 days to return, 2 warranty
Email support
Response within 24h to 72h
Secure payment
SSL, VISA, Mastercard, Paypal
Copyright 2014-2024 - Passion Radio / 4 MY PEOPLE.
Les photos et coloris ne sont pas contractuels.