Broadcast AM Band Cut filter by RTL-SDR.com RTL-SDR.com SDR accessory FILTRE-RTLSDR-523 View larger

RTL-SDR.com

FILTRE-RTLSDR-523

New product

China

Broadcast AM Band Cut filter by RTL-SDR.com

rating No review at the moment

This high-pass notch filter is designed by RTL-SDR.com and rejects the AM broadcast from 500 kHz to 1.7 MHz, with attenuation of more than 50dB.

In fact, because of the attenuation, the filter is usable from 2.5 - 2.6 MHz and above.

This AM radio band rejector filter will be useful if you are subject to strong broadcast signals that disturb reception on other bands.

Comes with: 1 AM Band-Stop Broadcast Filter RTL-SDR and an adapter SMA-Male.

More details

23,00 € tax excl.

In stock

   9 Items

Data sheet

Filter Type: LC High Pass Filter
3 dB Cutoff: 2.5 – 2.6 MHz
Attenuation: ~60dB
Pass band I.L: Typically well below 2 dB
Power Levels: RX power only, cannot pass DC

Reviews

Click here to leave a review

Additional or similar equipment

  • SMA Male UHF Female Adapter (SO-239)

    SMA Male to UHF Female Adapter (SO-239).

    5,00 € tax incl.

    4,17 €tax excl.

    In stock
  • Pigtail SMA Male to UHF Male 15cm RG316

    SMA Male to UHF Male pigtail adapter. RG 316 coaxial cable 50 ohms, 15cm long.

    7,50 € tax incl.

    6,25 €tax excl.

    In stock
  • Pigtail SMA Male UHF Female 15/50/100cm RG316

    Adapter cable pigtail SMA Male to plug UHF Female. RG 316 50 ohm coaxial cable. Available in 3 lengths: 15, 50 and 100 cm.

    5,90 € tax incl.

    4,92 €tax excl.

    In stock
  • Active 0-50 Mhz mini antenna for SDR receiver

    This Mini-Whip SDR active mini-antenna enables reception of HF frequencies from 0 to 50 mhz with an SDR receiver. Compact in size, the Mini-Whip active antenna can be used as a stand-alone device

    25,90 € tax incl.

    21,58 €tax excl.

    In stock
  • LNA preamplifier for HF SDR 500 kHz to 30 MHz from F1OPA

    The LNA HF from F1OPA is a pre-amplifier and a low-pass filter (LNA), very powerful (+18dB to +20dB), with SMA Female connectors, for HF frequencies and short waves from 500 kHz to 30 MHz, with

    35,50 € tax incl.

    29,58 €tax excl.

    In stock
  • Adapter SMA Male

    This RF adapter is fitted with a male SMA connector on both sides. It can be used to connect 2 SMA female cables or connectors, for example.

    4,50 € tax incl.

    3,75 €tax excl.

    In stock
  • HF Antenna Balun 1:9 for SDR

    This balun is the perfect accessory to connect a long wire antenna, for example with the converter HF SDR Ham it Up to listen shortwave and HF bands from 0.5 to 30Mhz, but this balun can work up to

    18,86 € tax incl.

    15,72 €tax excl.

    In stock
  • RSP1A SDRPlay receiver 1 kHz to 2 GHz 14-bit + LNA

    New version of the SDRPlay wideband receiver, the RSP1A now covers all frequencies from 1 kHz to 2 GHz without hole, all modes, with up to 10 MHz bandwidth on the screen and 14-bit sampling. In

    135,00 € tax incl.

    112,50 €tax excl.

  • Dongle RTL-SDR.com V3 TCXO + SMA + Bias-T USB stick with R860 tuner

    This USB stick is the optimized V3 version of RTL-SDR.com, with the R860 tuner chip (exactly the same as R820T2*) for reception from 24 to 1766 MHz. The characteristics of the dongle RTL-SDR.com v3:-

    45,91 € tax incl.

    38,26 €tax excl.

    In stock
  • Broadcast FM Band Cut filter by RTL-SDR.com

    This band-cut filter is design by RTL-SDR.com, it blocks and reject broadcast FM band between 88 to 108 MHz with over 50dB of attenuation. Insertion loss is less than 0.5 dB between 0-1 GHz, and less

    23,00 € tax incl.

    19,17 €tax excl.

    In stock
  • Active Loop antenna MLA-30 Plus MegaLoop 500 Khz - 30 Mhz

    MLA-30 Plus magnetic loop active antenna for receiving HF bands from 500 kHz to 30 MHz.The MLA-30+ antenna can be used with the RTL-SDR V3 stick in direct conversion mode, with the Ham it up

    49,90 € tax incl.

    41,58 €tax excl.

    In stock
  • Diamond CMF-2000 common mode filter TVI RF choke

    The Diamond CMF-2000 is a common mode filter that will prevent TVI and EMI CEM interference, caused by the transmission coaxial cable.Usable from 1 to 54 Mhz all bands, HF amateur radio, CB 27 Mhz,

    154,90 € tax incl.

    129,08 €tax excl.

    Out of stock, available in 2 to 3 months
  • Ham It Up Plus V2 Nooelec UpConverter SDR HF 0.3 to 65MHz with TCXO & box

    RF converter (ULF/VLF/LF/MF/HF) for HF frequencies from 0.3 to 65 MHz and SDR (Software Defined Radio) devices such as NESDR keys, RTL-SDR, HackRF, or any VHF or SDR receiver covering the 125MHz to

    99,00 € tax incl.

    82,50 €tax excl.

    In stock
  • Balun One Nine v2 HF 9:1 Nooelec with aluminium housing

    Small 9:1 balun/unun (38 mm x 25.0 mm) designed to connect long wires and HF dipole antennas to your SDR HF radio, radio or Ham It Up HF upconverter. Assembled in a bespoke aluminium housing, it

    32,40 € tax incl.

    27,00 €tax excl.

    In stock
  • Ham It Up Nano 100kHz-65MHz HF Upconverter with TCXO Bias-Tee power supply unit

    The Ham It Up Nano is an HF upconverter that lets you extend the range of your favourite SDR or radio to at least 100kHz. It is compatible with any radio capable of operating on 125MHz-190MHz (to use

    75,87 € tax incl.

    63,23 €tax excl.

    In stock
  • Malachite SDR V5 10kHz-250MHz and 400MHz-2GHz receiver with DSP

    The Malachite DSP SDR V5 receiver is a robust radio receiver with an aluminium casing offering a wide frequency coverage range from 10 kHz to 250 MHz and from 400 MHz to 2 GHz. This model incorporates

    295,00 € tax incl.

    245,83 €tax excl.

    In stock

Delivery Europe & Overseas

Stock and shipped from France

Product return

14 days to return, 2 warranty

Email support

Response within 24h to 72h

Secure payment

SSL, VISA, Mastercard, Paypal

Copyright 2014-2025 - Passion Radio / 4 MY PEOPLE.
Les photos et coloris ne sont pas contractuels.