Viewed products
EDUP EP-AB003 amplifier for the amateur radio...
EDUP EP-AB003 amplifier for the amateur radio band 2400Mhz (13cm), this 2.4Ghz amp of 8W theoretical, is able to deliver an effective power of 3-4W max. with an input of 100mW maximum.
This equipment can be used with the following SDR hardware: LimeSDR mini, HackRF One, Adalm-Pluto.
It is compatible for use in 2.4Ghz transmission on the QO-100 amateur radio satellite.
Comes with: 1 EDUP EP-AB003 2.4Ghz RF Amplifier, 1 power charger 220V, 1 cable RP-SMA Male (reverse SMA) - SMA Male, 1 WIFI antenna 6dBi in RP-SMA.
Material only reserved for amateur radio use only and on amateur satellite band from 2400 to 2450Mhz.
Frequency range: 2400 - 2500 MHz
Max. Input power : 100mW
Max. Output power : Theoretical 8W - 4W maximum according to use
Impedance: 50 Ohms
Connector: SMA Female (TX side) and RP-SMA female (RX side antenna)
Operating mode: bidirectional, half duplex, automatic switching via carrier detection
Frequency response: ± 1dB
Input power: 5 to 20 dBm
Optimum input power recommended: 15-16dBm
Gain transmission: 17 dBm nominal
Gain reception: 11dBm
Operating temperature: -40 to 70 degrees
Operating humidity: Relative humidity up to 95%
Aluminum case
Weight: 650g
Size: 8x8x2.5cm
2 years warranty*
This material is intended only for amateur radio use on the 13cm band, 2400-2450Mhz.
* The warranty does not cover PA and loss of power, which may result from assembly error, incorrect antenna adjustment (ROS), maximum input power not respected, short -circuit of the power supply or on the coaxial line.
Reference: ADAPT-RP-SMA-M-SMA-M-262
This RF adapter converts an RP-SMA Male connector to an SMA Male connector. Please note that this adapter is a Reverse SMA, mainly used in WIFI connectivity.
Reference: ADAPT-RP-SMA-F-SMA-F-263
This RF adapter converts a femaleRP-SMA connector to a female SMA connector. Please note that this adapter is a Reverse SMA, mainly used for WIFI applications.
Reference: ADAPT-RP-SMA-F-SMA-M-289
This RF adapter converts a femaleRP-SMA connector to a male SMA connector. Please note that this adapter is a Reverse SMA, mainly used for WIFI applications.
Reference: ADAPT-RP-SMA-M-SMA-F-290
This RF adapter converts an RP-SMA Male connector to an SMA Female connector. Please note that this adapter is a Reverse SMA, mainly used for WIFI equipment. Also compatible with hotspot equipment for
Click here to leave a review
Be the first to ask a question about this product!
This RF adapter converts an RP-SMA Male connector to an SMA Male connector. Please note that this adapter is a Reverse SMA, mainly used in WIFI connectivity.
3,17 €tax excl.
This RF adapter converts a femaleRP-SMA connector to a female SMA connector. Please note that this adapter is a Reverse SMA, mainly used for WIFI applications.
4,13 €tax excl.
This RF adapter converts a femaleRP-SMA connector to a male SMA connector. Please note that this adapter is a Reverse SMA, mainly used for WIFI applications.
3,75 €tax excl.
This RF adapter converts an RP-SMA Male connector to an SMA Female connector. Please note that this adapter is a Reverse SMA, mainly used for WIFI equipment. Also compatible with hotspot equipment for
2,92 €tax excl.
The POTY (Patch Of The Year) antenna is a dual-band 2.4 GHz /10 GHz antenna, with left-hand circular polarization LHCP for 2400 MHz transmission and a linear horn antenna for 10500 MHz reception with
57,50 €tax excl.
Printed circuit PCB wifi antenna WA5VJB Quad Patch for 2.4Ghz with a gain of 12dBi.The antenna is delivered without connector (solder wire).Frequencies: 2400-2480 MHz (WIFI 2.4 Ghz)Type: Patch
9,00 €tax excl.
21,60 € -50%The Analog Devices CN0417 is a small RF power amplifier, powered by micro-USB, optimized to operate on 2400 MHz with 100mW max, gain of 20-21dB max., with a integrated bandpass filter 2400 to
57,50 €tax excl.
This bandpass filter for the 2.4 Ghz (13cm) allows to reject the local oscillator and harmonics frequencies of the Up-Converter for QO-100 to get a clean signal on the satellite, with a max. input
22,42 €tax excl.
This V2 version of DJ7GP's 2.4 / 10 Ghz dualband feed antenna is ready for use in RX and TX LHCP Circular Polarized for 2400 MHz and 10500 MHz reception for Oscar-100 satellite via LNB head climb.
112,50 €tax excl.
KSR195 low-loss 50-ohm coaxial extension cable for use from 0 to 6Ghz, with angled SMA connector and straight male SMA connector.Available lengths: 50cm, 80cm, 1, 2, 5 and 10 meters Connector 1: SMA
6,58 €tax excl.
This power amplifier equipment with a gain of 30dB is intended to operate primarily with F1OPA's upconverter 144 / 432Mhz - 2400 MHz to traffic on the QO-100 satellite uplink with 100mW output (20dBm)
40,94 €tax excl.
The Taoglas Airvu 2.4Ghz bandpass filter is a 100Mhz broadband filter, for use in frequency from 2400 to 2500Mhz and a maximum power of 10W.Connector 1: RP-SMA MaleConnector 2: RP-SMA Female Note: The
12,04 €tax excl.
28,90 € -50%The TX QO-100 Passion Radio pack includes the main components for transmitting from a 28, 50, 144 or 430 MHz analogue SSB transceiver to the 2.4 GHz uplink channel of the QO-100 amateur radio
457,50 €tax excl.
The DXpatrol 2400Mhz V2 amplifier is intended to be used with the DXPatrol transverter for QO-100, from version MK2.It allows to output 12W maximum from an input between 50mW and 100mW maximum.
Very low-loss coaxial cable with male SMA connector on each end, for connecting, for example, a 2.4 Ghz amp to an OQ-100 transverter, or any use requiring a very low-loss cable like the RG402. RG 402
5,00 €tax excl.
Very low-loss RG-402 coaxial cable with a straight male SMA connector on one end and an angled SMA connector on the other. For connecting, for example, a 2400 MHz amplifier to an OQ-100 converter, or
5,42 €tax excl.
RG-402 ultra-low-loss coaxial cable with male SMA connector angled on 2 sides, 50 ohm ultra-low-loss cable, 10 cm long. Note: This rigid cable can be bent, but once installed in its position of use,
5,83 €tax excl.
This 10cm long, very low-loss RG402 coaxial cable converts an RP-SMA Male connector to an SMA Male connector. Please note that this adapter is a Reverse SMA, mainly used for WIFI applications. Note:
5,00 €tax excl.
This very low-loss rigid RG402 coaxial connector, 10cm, 15cm or 20cm long, can be used to convert an RP-SMA Male connector to an SMA Female connector. WarningThis adapter is a Reverse SMA (RP-SMA),
4,92 €tax excl.
The NanoVNA V2 SAA2N is an antenna and vector network (VNA) analyzer that covers the HF, VHF and UHF bands from 50 KHz to 3000 MHz, with N or SMA type connector and a metal case.It measures the
Variable gain pre-amplifier with 15dBGain control in 1 dB stepsAdditional filtering for the 2.4 GHz bandPower supply 8-30 V DCOutput detector This equipment is intended for amateur radio use only on
The SG LAB 2400 MHz V3 amplifier is intended to be used for amateur radio traffic on the QO-100 satellite and the 2.4 Ghz channel. It allows to output up to 20W maximum from an input between 40mW and
The SG LABS 13cm v1.4 transverter for QO-100, allows transmitting from a 432 MHz UHF SSB station to 2400 MHz (13cm) on the uplink channel of the QO-100 satellite with a maximum output power of 2W.
VHF/UHF/SHF digital and analog amateur radio base IC-905, all modes coverage: 144/430/1200MHz (10W), 2400/5600MHz (2W) and 10GHz (0.5W) with CX-10G (optional). All modes: SSB, CW, AM, FM, D-STAR
3 332,50 €tax excl.
The new Upconverter-H from Localino and for QO-100 makes it quick and easy to get up and running on the QO100 satellite using an SSB transceiver in 28/50/144 or 432 MHz, with a maximum power of 5W on
329,17 €tax excl.
The RemoteQTH 10 GHz LNB EXT OSC MK3 pack is an advanced system comprising an ultra-low-noise converter block and a Bias Tee, optimised for receiving 10 GHz satellite signals with exceptional
140,83 €tax excl.
13cm 2.4GHz amplifier for QO-100 compatible with the use of a Adalm Pluto to be operational on the QO-100 satellite in SDR with a maximum power of 10W on the 13cm 2.4 GHz band. With integrated TCXO,
332,50 €tax excl.
RigExpert's 2.4GPA power amplifier is designed to operate in the 2.0 to 2.6 GHz frequency band, including 2.4GHz frequencies. It can be used with an input power of 9-14.5 dBm (8-28mW) and a maximum
215,83 €tax excl.
Stock and shipped from France
14 days to return, 2 warranty
Response within 24h to 72h
SSL, VISA, Mastercard, Paypal
Copyright 2014-2024 - Passion Radio / 4 MY PEOPLE.
Les photos et coloris ne sont pas contractuels.