No products
New products
-
2.4GHz TX 2.5W Max Bidirectional Amplifier + 10dB RX Preamp
259,00 € tax excl. -
-
Switching power supply MOONRAKER SM-30II 30A
99,00 € tax excl. -
USB CAT & PTT Control Interface Digirig DR-891 for YAESU FT-891
99,00 € tax excl.
Viewed products
-
NOOELEC Flamingo v2 FM...
The Flamingo v2 FM is a high-attenuation FM...
-
6000 mAh battery for Inrico T368
10,38 € -50% 20,75 €
NOOELEC Flamingo v2 FM notch filter in box for software-defined radio (SDR)
No review at the momentThe Flamingo v2 FM is a high-attenuation FM notch filter, shielded against electromagnetic interference by a custom anodised aluminium housing.
- +70dB attenuation in the FM band
- FM Broadcast radio (commercial)
- 46.6MHz 3dB bandwidth
- 34.3MHz 10dB bandwidth
- 50Ω impedance
Supplied with: 1 Flamingo V2 band-cut filter and a male SMA-male connector.
Download
Data sheet
Flamingo+ FM has been designed to provide sufficient attenuation for FM broadcast frequencies (>60dB typical average and >70dB typical maximum stopband attenuation) while ensuring that adjacent bands, such as the important VHF air band (108-137MHz), are minimally affected.
The -3dB attenuation of the filter is 75MHz and 120MHz, and the -10dB attenuation of the filter is 80MHz and 116MHz.
These are generally urban areas, but also rural areas where there are high-power FM transmitters nearby. For other locations, we strongly recommend considering the original Flamingo FM v1, which has lower stopband attenuation, but also lower attenuation of the nearby VHF airband (108-137MHz), as well as otherwise similar out-of-band characteristics and performance.
It probably sounds more complicated than it actually is. For more information and to determine whether it is suitable for your particular application, we strongly recommend that you consult the full graphics and performance characteristics available in the 'Downloads' tab of the product page. It will be much easier to assimilate the information.
The minimum out-of-band insertion loss (<0.25dB) means that the filter can remain in place for most applications. The recommended maximum signal level is +18dBm (5Vp-p), so there's no problem using the filter if you have higher power requirements than most people. As this is a true notch filter, it is possible to pass DC (bias power) when required. DC current handling is 250mA (min).
The front end of Flamingo+ FM is protected by an ESD diode designed for RF applications. Designed and manufactured by Nooelec in North America, with a full 2-year product warranty.
Customers also bought
23,00 €Reference: FILTRE-RTLSDR-FM-473
Broadcast FM Band Cut filter by RTL-SDR.com
This band-cut filter is design by RTL-SDR.com, it blocks and reject broadcast FM band between 88 to 108 MHz with over 50dB of attenuation. Insertion loss is less than 0.5 dB between 0-1 GHz, and less
23,00 €
13,20 €Reference: NAGOYA-NA771-MALE-4572
Antenna Nagoya NA-771 2m/70cm SMA Female, SMA Male or BNC Male
This Nagoya walkie-talkie antenna with SMA Male, SMA female or BNC male connector (to be chosen below) increases performance on the 144 Mhz and 430 Mhz bands, the antenna is 39cm long.The SMA Female
13,20 €
35,90 €Reference: NOO-LANA2-100802-908_2
Nooelec LaNA LNA preamp 20MHz - 4GHz + case + USB DC Bias-T
Nooelec's LANA is a high-gain, 20 MHz - 4 GHz wide band LNA amplifier for SDR applications, with low power consumption and better linearity than the SPF5189Z LNA.The LaNa has 3 different power
35,90 €Online only
5,00 €Reference: ADAPT-SMA-M-BNC-F-85
SMA Male BNC Female Adapter
SMA Male to BNC Female adapter. Compatible with Ham It Up HF converter card, HackRF and the SDR receiver FUNcube Dongle Pro+ receiver.
5,00 €
We also recommend
319,00 €Reference: GSG-HACKRF-BOITE-75
HackRF One SDR Transceiver TX RX 1-6000MHz - RF development board - Genuine Version
The HackRF One is a SDR receiver-transmitter covering from 1MHz to 6GHz in all available modes, analog and digital.Tip: For use in the lab, or with strong signals nearby, the sensitivity of the device
319,00 €
31,92 €Reference: NOOELEC-100722-OUTERNET-467
LNA & SAW filter for Inmarsat and Outernet
This LNA and SAW filter from Nooelec is specially designed to operate on 1.5Ghz Outernet frequency band and for Inmarsat radio applications, covering from 1.50GHz to 1.58GHz. It significantly
31,92 €
135,00 €Reference: SDRPLAY-RSP1-356
RSP1A SDRPlay receiver 1 kHz to 2 GHz 14-bit + LNA
New version of the SDRPlay wideband receiver, the RSP1A now covers all frequencies from 1 kHz to 2 GHz without hole, all modes, with up to 10 MHz bandwidth on the screen and 14-bit sampling. In
135,00 €
45,91 €Reference: CLE-RTLSDR-V3-472
Dongle RTL-SDR.com V3 TCXO + SMA + Bias-T USB stick with R860 tuner
This USB stick is the optimized V3 version of RTL-SDR.com, with the R860 tuner chip (exactly the same as R820T2*) for reception from 24 to 1766 MHz. The characteristics of the dongle RTL-SDR.com v3:-
45,91 €Online only
Reviews
Additional or similar equipment
-
HackRF One SDR Transceiver TX RX 1-6000MHz - RF development board - Genuine Vers
The HackRF One is a SDR receiver-transmitter covering from 1MHz to 6GHz in all available modes, analog and digital.Tip: For use in the lab, or with strong signals nearby, the sensitivity of the device
319,00 € tax incl.In stock265,83 €tax excl.
-
RSP1A SDRPlay receiver 1 kHz to 2 GHz 14-bit + LNA
New version of the SDRPlay wideband receiver, the RSP1A now covers all frequencies from 1 kHz to 2 GHz without hole, all modes, with up to 10 MHz bandwidth on the screen and 14-bit sampling. In
135,00 € tax incl.112,50 €tax excl.
-
LNA & SAW filter for Inmarsat and Outernet
This LNA and SAW filter from Nooelec is specially designed to operate on 1.5Ghz Outernet frequency band and for Inmarsat radio applications, covering from 1.50GHz to 1.58GHz. It significantly
31,92 € tax incl.In stock26,60 €tax excl.
-
Dongle RTL-SDR.com V3 TCXO + SMA + Bias-T USB stick with R860 tuner
This USB stick is the optimized V3 version of RTL-SDR.com, with the R860 tuner chip (exactly the same as R820T2*) for reception from 24 to 1766 MHz. The characteristics of the dongle RTL-SDR.com v3:-
45,91 € tax incl.In stock38,26 €tax excl.
-
Broadcast FM Band Cut filter by RTL-SDR.com
This band-cut filter is design by RTL-SDR.com, it blocks and reject broadcast FM band between 88 to 108 MHz with over 50dB of attenuation. Insertion loss is less than 0.5 dB between 0-1 GHz, and less
23,00 € tax incl.In stock19,17 €tax excl.
Broadcast AM Band Cut filter by RTL-SDR.com
This high-pass notch filter is designed by RTL-SDR.com and rejects the AM broadcast from 500 kHz to 1.7 MHz, with attenuation of more than 50dB. In fact, because of the attenuation, the filter is
23,00 € tax incl.In stock19,17 €tax excl.
Nooelec VHF-UHF telescopic antenna kit for SDR
Nooelec VHF-UHF antenna pack for SDR reception on VHF and UHF bands, supplied with a magnetic base, 2m RG58 coaxial cable with male SMA connector and 3 antenna strands to screw on the base:1
16,90 € tax incl.In stock14,08 €tax excl.
Nooelec NESDR SMArTee v2 R820T2 dongle SDR + TCXO + Case + SMA + Bias-Tee
The NESDR SMARTee v2 is the version with the Bias-Tee function in addition to the NESDR Smart V4, equipped with the RTL2832U chipset and the R820T2 tuner which can receive from 25 to 1750MHz (without
56,45 € tax incl.In stock47,04 €tax excl.
Ham It Up Plus V2 Nooelec UpConverter SDR HF 0.3 to 65MHz with TCXO & box
RF converter (ULF/VLF/LF/MF/HF) for HF frequencies from 0.3 to 65 MHz and SDR (Software Defined Radio) devices such as NESDR keys, RTL-SDR, HackRF, or any VHF or SDR receiver covering the 125MHz to
99,00 € tax incl.In stock82,50 €tax excl.
Nooelec AAA battery pack for Ham It Up v1.3 and Ham It Up Plus V2
Easy-to-install battery box for Ham It Up upconverter, allowing the converter to operate for extended periods without connection to a power source. DC power from the battery greatly improves the
7,75 € tax incl.In stock6,46 €tax excl.
Balun One Nine v2 HF 9:1 Nooelec with aluminium housing
Small 9:1 balun/unun (38 mm x 25.0 mm) designed to connect long wires and HF dipole antennas to your SDR HF radio, radio or Ham It Up HF upconverter. Assembled in a bespoke aluminium housing, it
32,40 € tax incl.In stock27,00 €tax excl.
Nooelec VeGA variable gain amplifier LNA module Barebones 30MHz-4000MHz
The VeGA Barebones is a 30MHz to 4000MHz broadband linear LNA module designed to allow the user to control the level of amplification to achieve the best signal-to-noise ratio (SNR). The device can be
85,61 € tax incl.In stock71,34 €tax excl.
Downconverter 1.55 GHz to 3.1 GHz Nooelec Ham It Down with TCXO Bias-Tee
The Ham It Down is a downconverter capable of converting radio signals from 1.55 GHz to 3.1 GHz in the 50 MHz - 1.6 GHz frequency range and supported by SDR keys such as NESDR and RTL-SDR V3. It
124,86 € tax incl.In stock104,05 €tax excl.
Malachite SDR V5 10kHz-250MHz and 400MHz-2GHz receiver with DSP
The Malachite DSP SDR V5 receiver is a robust radio receiver with an aluminium casing offering a wide frequency coverage range from 10 kHz to 250 MHz and from 400 MHz to 2 GHz. This model incorporates
295,00 € tax incl.Available to order within 2-3 weeks245,83 €tax excl.
Delivery Europe & Overseas
Stock and shipped from France
Product return
14 days to return, 2 warranty
Email support
Response within 24h to 72h
Secure payment
SSL, VISA, Mastercard, Paypal
Copyright 2014-2024 - Passion Radio / 4 MY PEOPLE.
Les photos et coloris ne sont pas contractuels.