Reference: RIGEXPERT-24GPA-2961
RigExpert's 2.4GPA power amplifier is designed to operate in the 2.0 to 2.6 GHz frequency band, including 2.4GHz frequencies. It can be used with an input power of 9-14.5 dBm (8-28mW) and a maximum
215,83 €
Reference: RIGEXPERT-AA-ZERO-II-2960
The RigExpert ZERO II Antenna SWR Analyser board is a device for on-board installation and can be used, for example, in antenna tuners, transceivers or power amplifiers as the central element of the
Reference: MOON-99-578-SM30IIE-2959
The SM-30II is a robust switching power supply capable of delivering up to 30 amps. It is equipped with a noise offset control system to eliminate pulse noise from the switching circuit. Efficiency
Reference: DIGIRIG-DR891-2952
This version of the Digirig CAT, audio and PTT control interface is dedicated specifically to the Yaesu FT-891, but can be used with other models of transceivers if only the audio/PTT cable is
Reference: DIGIRIG-DRLITE-2948
Digirig Lite Rev 1.2 is the minimalist version of Digirig Mobile with the same audio codec but without the serial port.Combines audio codec and PTT switch Supports PTT through the GPIO3 of the CM108
Reference: DIGIRIG-DRMOB-2946
Digirig is an integrated USB interface for digital amateur radio modes (FT8, SSTV, RTTY, CW, VARA, etc.) combining an audio codec, a CAT serial interface and PTT control. All you need is a simple USB
Reference: ANYTONE-AT-6666-PRO-2870
Anytone AT-6666 PRO 10m 28 MHz amateur radio set with transmit and receive coverage from 28 to 29.7Mhz with 80W max. in SSB, 12V power supply.Modes: AM / FM / USB / LSB / CW / PA Frequencies: 28 -
Reference: PNI-PACK-HP446-2866
The PNI Escort HP 446 pack is a radio that can be used with a licence.Programmable in the PMR* frequency range: 400-470 MHz (UHF) Selectable transmit power: 15W, 5W or 0.5W Manual channel
Reference: GRAZIOLI-FE6V-2865
Grazioli FE6V 5/8λ omnidirectional antenna measuring 4.17m for the 6m band. The ground plane is made up of 4 robust quarter-wave radials 1.4m long. It has an adjustable frequency range from 50 to 54
Reference: XIEGU-BATT-X6200-B-2862
Original X62B 3200mAh battery and 7.6V replacement battery for the XIEGU X6200 transceiver. Supplied with: 1 official XIEGU battery for X6200.
Reference: SDRPLAY-NRSP-ST-2864
A new all-in-one receiver from SDRPlay, the nRSP-ST is a 14-bit SDR receiver with general coverage from 1 kHz to 2 GHz (without holes), integrating a receiver and a Web server with Ethernet or Wifi
479,17 €
Reference: TECSUN-S2200X-2650
AMATEUR RADIO receiver multimode AM, FM and SSB, covers frequency:FM: 76-108 MHz LW: 100-519 kHz MW (AM): 520-1710 kHz SW: 1711-30000 kHz Air: 118-137 MHzFM stereo via headphones or earphones
Reference: TTGO-TBEAM-SUPREME-433-H664-2825
Evolution of the LILYGO TTGO T-BEAM SUPREME Meshtastic, IoT development board for the LoRa 433 MHz ISM band, with 802.11 b/g/n WIFI connection , Bluetooth/BLE 5, soldered 2.4cm OLED screen, L76K GPS
Reference: TTGO-TBEAM-SUPREME-868-H661-2823
Evolution of the T-BEAM SUPREME board with Meshtastic firmware installed, IoT development board for the LoRa 868 MHz ISM band, with 802.11 b/g/n WIFI connection , Bluetooth/BLE 5, 2.4cm soldered OLED
Reference: SIRIO-SPO8689156N-2779
Antenna for ISM, Lora, Meshtastic, on the 868-915MHz ISM band without tuning. Max power 20W. Gain 6dBi. With N female connector.
Reference: SIRIO-HGO433868-2777
20W 433 & 868 MHz antenna with 5m low-loss RF100 cable and male SMA connector for Lora, Meshtastic, etc.
Reference: TTGO-T-ECHO-433-K185-2644
LILYGO TTGO T-Echo is the advanced version of the T-BEAM development board, and has been optimised for Bluetooth and power consumption, thanks to Meshtastic firmware optimisation and the use of the
82,23 €
Reference: GOODIES-CARNET-LOGBOOK-589
Radio Logbook "Passion Radio" with spirals on A5 landscape format paper, small size perfect for activity in mobile, portable, SOTA or IOTA.Four-color printed cover on a 300 gr satin card Inner
Reference: MTUNER-MAT-M200-CI-ICOM-2833_1
The mAT-M200 is an automatic antenna tuner, external and compatible with ICOM brand HF transceivers that supports the original AH-3 or AH-4 Icom tuner and Kenwood HF sets supporting the AT-250 or
Reference: INRAD-W1-2832
The INRAD W1 headset is a high quality, wide and comfortable headset that allows the ears to enter the padding, avoiding the pain of the ear pressed against the head. It features thick rubberised foam
Stock and shipped from France
14 days to return, 2 warranty
Response within 24h to 72h
SSL, VISA, Mastercard, Paypal
Copyright 2014-2024 - Passion Radio / 4 MY PEOPLE.
Les photos et coloris ne sont pas contractuels.