Viewed products
The key NESDR SMART v5 is the new and improved...
The key NESDR SMART v5 is the new and improved version of the famous USB RTL-SDR dongle with the RTL2832U chipset and the R820T2/R860tuner, to receive all frequencies without gaps from 100kHz to 1.75GHz with up to 3.2MHz instant bandwidth.
Improvements in the NESDR Smart 5 version:
RF SNR is improved by up to 15dB, VHF & UHF SNR is improved by up to 6dB, tuning accuracy is improved by an average of 4x, and the frequency range is extended to 100kHz.
RF reception below 25MHz is direct sampling and requires a suitable antenna. We recommend using the Balun 1:9 (One Nine) to make a dipole antenna or a long wire.
We always recommend using a converter such as the upconverter HF SDR Nano Ham It Up for a more satisfying HF experience and even better performance for frequencies from 0.1 to 65MHz.
Optional: Antenna pack with magnetic base and 2m RG58 cable with male SMA connector and 1 telescopic 75-1000MHz variable-frequency lead, 1 433MHz antenna lead (ISM band) and 1 fixed antenna lead for UHF frequency (GSM).
Supplied with : 1 Nooelec NESDR Smart V5 SDR dongle, without antenna or CD. With optional antenna pack, to be chosen below.
Other similar model if out of stock: RTL-SDR.com V3 dongle.
The USB key NESDR SMART is equipped with a 0.5ppm TCXO, ensuring frequency stability whatever the environment and temperature. In the quest for the lowest possible frequency noise, the power supply has been redesigned with a high-quality RF voltage regulator with less than 10μVRMS noise, around 10 times lower than the standard RTL2832+R820T2.
The inductor in the power supply is shielded to block as much ambient interference and noise as possible. The case also provides additional protection against interference.
A suitable heat sink has been added to dissipate heat away from the printed circuit board.Power consumption has been reduced by an average of 10mA, which means less heat is generated. Lhe result is an operating temperature well below the usual level, with improved stability and sensitivity.
With a SDR software for Windows linux or Mac, associated to other third-party software for decoding, this dongle can be used, for example, to decode a video signal.
Can be used, for example, to receive AM, FM, short-wave, ham radio, CB, ACARS (air-to-ground communications), ADS-B (aircraft tracking), AIS (ship tracking), POCSAG (pagers), NOAA and GOES weather satellites (weather images), weather balloons, radiosondes, DAB radio, DVB-T video, Inmarsat, Iridium, and much more!
The NESDR SMArt v5 was officially launched in 2022 and you may already have a V5 in your hands.
You can check that you have a v5 by looking at the underside of the SDR key and looking for the v5 logo. If you don't see a logo, you have a version between v1 and v4.
Reference: PIGTAIL-SMA-M-UHF-F-80
Adapter cable pigtail SMA Male to plug UHF Female. RG 316 50 ohm coaxial cable. Available in 3 lengths: 15, 50 and 100 cm.
Reference: CLE-RTLSDR-V3-472
This USB stick is the optimized V3 version of RTL-SDR.com, with the R860 tuner chip (exactly the same as R820T2*) for reception from 24 to 1766 MHz. The characteristics of the dongle RTL-SDR.com v3:-
Reference: PIGTAIL-SMA-M-SMA-M-81
SMA Male to SMA Male pigtail adapter, for connecting a card, for example converter Ham it upconverter card to the SDR transceiver HackRF One SDR transceiver, or the SDRPlay broadband receiverwideband
Reference: ADAPT-SMA-F-SMA-F-292
This RF adapter has a female SMA connector on both sides.It can be used to connect 2 SMA male cables or connectors, for example.
Reference: NOO-100721-HAM-IT-UP-PLUS-441
Nooelec's Ham It Up v1.3 is an up-converter HF, equipped with the 125Mhz filter soldered on the PCB and allows to listen to all MF / HF bands from 0.5 to 50 Mhz, in all modes of modulation, from a
Reference: ADAPT-SMA-M-UHF-F-67
SMA Male to UHF Female Adapter (SO-239).
Reference: PIGTAIL-SMA-M-UHF-F-80
Adapter cable pigtail SMA Male to plug UHF Female. RG 316 50 ohm coaxial cable. Available in 3 lengths: 15, 50 and 100 cm.
Reference: PIGTAIL-SMA-M-SMA-M-81
SMA Male to SMA Male pigtail adapter, for connecting a card, for example converter Ham it upconverter card to the SDR transceiver HackRF One SDR transceiver, or the SDRPlay broadband receiverwideband
Click here to leave a review
Il faut cependant une bonne antenne bien dégagée quand il n'est pas possible d'en installer je pense que l'antenne télescopique intérieure n'est pas suffisante quand on est situé en campagne .
Le ppm testé avec kalibrate-rtl est conforme à la description. Plus cher mais bien plus précis que tous les modèles vendus aux alentours de 20€ dans d'autres boutiques.
Super produit alliant compacité et capacités. Répond tout à fait à ce que j'attendais.
Be the first to ask a question about this product!
Nooelec's Ham It Up v1.3 is an up-converter HF, equipped with the 125Mhz filter soldered on the PCB and allows to listen to all MF / HF bands from 0.5 to 50 Mhz, in all modes of modulation, from a
62,50 €tax excl.
SMA Male to UHF Female Adapter (SO-239).
4,17 €tax excl.
Adapter cable pigtail SMA Male to plug UHF Female. RG 316 50 ohm coaxial cable. Available in 3 lengths: 15, 50 and 100 cm.
4,92 €tax excl.
SMA Male to SMA Male pigtail adapter, for connecting a card, for example converter Ham it upconverter card to the SDR transceiver HackRF One SDR transceiver, or the SDRPlay broadband receiverwideband
4,17 €tax excl.
This model of RTL-SDR key is equipped with the Realtek RTL2832U chipset and the new R860 tuner, which is identical to the R820T2 tuner and has been specially designed for SDR mode. The antenna
21,58 €tax excl.
The LNA4ALL is a pre-amplifier and a low-pass filter (LNA) with SMA female RF connectors and for RF frequencies covering all bands from 28MHZ to 2500 MHz. It improves greatly reception performance, on
37,42 €tax excl.
This RF adapter is fitted with a male SMA connector on both sides. It can be used to connect 2 SMA female cables or connectors, for example.
3,75 €tax excl.
This balun is the perfect accessory to connect a long wire antenna, for example with the converter HF SDR Ham it Up to listen shortwave and HF bands from 0.5 to 30Mhz, but this balun can work up to
15,72 €tax excl.
This Nooelec USB RTL-SDR stick is equipped with the Realtek chipset RTL2832U and E4000 tuner offering a wider frequency coverage than R820T2. Antenna connection in MCX female on the dongle.
43,57 €tax excl.
This USB stick is the optimized V3 version of RTL-SDR.com, with the R860 tuner chip (exactly the same as R820T2*) for reception from 24 to 1766 MHz. The characteristics of the dongle RTL-SDR.com v3:-
38,26 €tax excl.
This band-cut filter is design by RTL-SDR.com, it blocks and reject broadcast FM band between 88 to 108 MHz with over 50dB of attenuation. Insertion loss is less than 0.5 dB between 0-1 GHz, and less
19,17 €tax excl.
144/430 MHz dual band antenna Diamond X30 (SO239 female UHF connector) and X30N (female N-plug connector), with radians.Length: 1.3mLength of the radians: 19cmGain: 3.0dBi (144MHz) and 5.5dBi
49,17 €tax excl.
VHF-UHF telescopic dipole antenna pack for SDR reception and with a flexible tripod and suction pad. This antenna set includes 1 dipole antenna support with 60cm of cable and with male SMA connector,
8,33 €tax excl.
Dual-band Diamond antenna X50 144/430MHz (2m/70cm). Type:6/8 wave (144MHz), 3x 5/8 wave C-Load radialless (430MHz)Length: 1.7mWeight: 0.9kg Gain: 4.5dB (144MHz), 7.2dBi (430MHz) Max.power:
65,83 €tax excl.
The Start ADS-B pack allows you to have a portable station for receiving ADS-B messages from aircraft and to follow their movements on a map in real time, via a Windows or Linux computer.Included in
45,75 €tax excl.
The new version Nooelec Balun 1:9 v2 allows to add a wired or dipole antenna type to listen HF bands from 0 to 30Mhz from the Ham It Up converter, an SDRPlay receiver or equivalent covering the HF
20,24 €tax excl.
MLA-30 Plus magnetic loop active antenna for receiving HF bands from 500 kHz to 30 MHz.The MLA-30+ antenna can be used with the RTL-SDR V3 stick in direct conversion mode, with the Ham it up
41,58 €tax excl.
Super Discone Diamond D-190 antenna, for fixed installation on a mast, allows to receive from 100 MHz to 1500 MHz and to transmit on 144/430/904 and 1200 MHz.Length: 0.84mWeight: 0.52 kgRadian
82,50 €tax excl.
Super Discone Diamond D-150 antenna, for fixed installation on a mast, allows to receive from 50 MHz to 1500 MHz and to transmit on 50/144/430/904 and 1200 MHz.Length: 1.04mWeight: 0.62 kgRadian
103,33 €tax excl.
The Passion Radio SDR Deluxe Plus V4 pack provides reception coverage between 0.5 to 1766 MHz from a computer running Windows, Mac or Linux.This V4 version of the pack includes:- 1 RTL-SDR.com V3
132,50 €tax excl.
Nooelec VHF-UHF antenna pack for SDR reception on VHF and UHF bands, supplied with a magnetic base, 2m RG58 coaxial cable with male SMA connector and 3 antenna strands to screw on the base:1
14,08 €tax excl.
The NESDR SMARTee v2 is the version with the Bias-Tee function in addition to the NESDR Smart V4, equipped with the RTL2832U chipset and the R820T2 tuner which can receive from 25 to 1750MHz (without
47,04 €tax excl.
Balun portable 9:1 Antenna Balun SDR Receiver Accessory with 16.5m red wire and 10m blue wireSpecification:- Maximum power: 10W- Red wire: 16.5m- Blue wire: 10m- Weight: 335gIncluded in the package:-
24,10 €tax excl.
7mm Black Ferrite Choke Balun for EMC Demagnetization Filter Anti-interference Device Clip-on VersionDescription:- It can filter high frequency noise, pulse interference from connection circuits.-
1,60 €tax excl.
The RTL-SDR.com V4 USB SDR key incorporates the R828D tuner (instead of the R860 in V3) for reception from 500kHz to 1766 MHz.TCXO at 1 PPM Female SMA antenna connector Realtek RTL2832U chipset +
34,55 €tax excl.
RF converter (ULF/VLF/LF/MF/HF) for HF frequencies from 0.3 to 65 MHz and SDR (Software Defined Radio) devices such as NESDR keys, RTL-SDR, HackRF, or any VHF or SDR receiver covering the 125MHz to
82,50 €tax excl.
Small 9:1 balun/unun (38 mm x 25.0 mm) designed to connect long wires and HF dipole antennas to your SDR HF radio, radio or Ham It Up HF upconverter. Assembled in a bespoke aluminium housing, it
27,00 €tax excl.
The Ham It Up Nano is an HF upconverter that lets you extend the range of your favourite SDR or radio to at least 100kHz. It is compatible with any radio capable of operating on 125MHz-190MHz (to use
63,23 €tax excl.
The Ham It Down is a downconverter capable of converting radio signals from 1.55 GHz to 3.1 GHz in the 50 MHz - 1.6 GHz frequency range and supported by SDR keys such as NESDR and RTL-SDR V3. It
104,05 €tax excl.
A new version of SDRPlay's receiver, the RSP1B covers all frequencies from 1 kHz to 2 GHz without gaps, in all modes*, with up to 10 MHz of screen bandwidth and 14-bit sampling. The differences with
129,06 €tax excl.
The Malachite DSP SDR V5 receiver is a robust radio receiver with an aluminium casing offering a wide frequency coverage range from 10 kHz to 250 MHz and from 400 MHz to 2 GHz. This model incorporates
245,83 €tax excl.
Stock and shipped from France
14 days to return, 2 warranty
Response within 24h to 72h
SSL, VISA, Mastercard, Paypal
Copyright 2014-2024 - Passion Radio / 4 MY PEOPLE.
Les photos et coloris ne sont pas contractuels.