LNA preamp with BIAS-T for HackRF Airspy SDRPlay SDR accessory LNA4ALL2-288 View larger

LNA4ALL2-288

New product

LNA preamp with BIAS-T for HackRF Airspy SDRPlay

rating Read the review
Average rating: 5/5 Number of reviews: 1

Preamplifier and LNA (low noise amplifier) specially adapted with BIAS-T for HackRF One, AirSpy, SDRPlay and RTL-SDR V3 usb stick.

It highly increases the reception performance (+ 11dB to + 23dB) and operates on frequencies from 28MHz to 2500MHz (2.5Ghz).

This version of LNA4ALL, modified by the original designer, allows to be powered directly via the SMA wiht BIAS-T + 3.3V power of HackRF One, Airspy, SDRPlay and RTL-SDR V3 USB stick.

Note: This version can only be powered by SMA, the power mode 6V/9V directly on the card is no longer possible with this modified model.

See also the LNA4HF version for shortwave and HF bands from 150kHz to 30Mhz.

This material is currently no longer available and we do not know when it will be available again.

Equivalent model: LNA PGA-103 50-2500Mhz F1OPA preamp.

Other model available: LNA 50-4000 Mhz preamplifier with SPF5189Z.

See also the LNA HF F1OPA version for 150KHz to 30MHz preamplifier HF bands.

More details

This material is no longer available

Data sheet

LNA4ALL for HackRF & AirSpy

Power supply: Power through SMA of HackRF or Airspy
Consumption: 18mA
Frequency range: 28MHz - 2500MHz
Receive gain: 11 to 23dB (cf. diagram)
NF: 0.75dB @ 1GHz
Amplifier: PGA-103+ (PGA103)
Impedance: 50 ohms
Antenna Connector: SMA Female
Dimension: 25x25 mm

VERY IMPORTANT

This preamplifier LNA is highly efficient and need to be use with caution, never use near strong signals (FM radio station amateur radio, walkie-talkie, etc.) under penalty of "grill" your device immediately SDR HackRF One or AirSpy!

How to protect the LNA from ESD?

The static discharge can damage the LNA if it is not protected and used properly.

1 - Never leave the LNA plugged permanently or placed permanently behind an antenna on the mast
2 - Disconnect the antenna and ensure proper grounding of the LNA and antenna, before reconnecting the antenna cable discharging static electricity
3 - It is also possible to add extra protection diode BAV99 welding (scratch first location) to the input of the antenna as shown in green on the following picture:

So if lightning the diode will be damaged but not the rest of the LNA card.

No LNA will be returned or exchanged due to misuse.

The warranty does not cover damage that may result from an assembly error, an incorrect antenna setting (ROS), a maximum input power not respected, a short circuit of the power supply or coaxial line and damage from electrostatic discharge.

Reviews

Click here to leave a review

rating 5
Fonctionne très bien!
Ce préampli fonctionne très bien : il y a une réelle différence ! Pour le HackRF, l'activation logicielle (avec gqrx) est réalisée en ajoutant le paramètre "bias=1".

Additional or similar equipment

  • SMA Male UHF Female Adapter (SO-239)

    SMA Male to UHF Female Adapter (SO-239).

    5,00 € tax incl.

    4,17 €tax excl.

    In stock
  • Pigtail SMA Male UHF Female 15/50/100cm RG316

    Adapter cable pigtail SMA Male to plug UHF Female. RG 316 50 ohm coaxial cable. Available in 3 lengths: 15, 50 and 100 cm.

    5,90 € tax incl.

    4,92 €tax excl.

    In stock
  • Pigtail SMA Male - SMA Male 15/30/50/100cm RG316

    SMA Male to SMA Male pigtail adapter, for connecting a card, for example converter Ham it upconverter card to the SDR transceiver HackRF One SDR transceiver, or the SDRPlay broadband receiverwideband

    5,00 € tax incl.

    4,17 €tax excl.

    In stock
  • LNA preamplifier for HF SDR 500 kHz to 30 MHz from F1OPA

    The LNA HF from F1OPA is a pre-amplifier and a low-pass filter (LNA), very powerful (+18dB to +20dB), with SMA Female connectors, for HF frequencies and short waves from 500 kHz to 30 MHz, with

    35,50 € tax incl.

    29,58 €tax excl.

    In stock
  • LNA VHF UHF preamplifier with PGA-103 + for RF and SDR application

    The LNA4ALL is a pre-amplifier and a low-pass filter (LNA) with SMA female RF connectors and for RF frequencies covering all bands from 28MHZ to 2500 MHz. It improves greatly reception performance, on

    44,90 € tax incl.

    37,42 €tax excl.

    In stock
  • Adapter SMA Male

    This RF adapter is fitted with a male SMA connector on both sides. It can be used to connect 2 SMA female cables or connectors, for example.

    4,50 € tax incl.

    3,75 €tax excl.

    In stock
  • Nooelec RF Shield Kit for HackRF One

    This RF shield Nooelec and component kit is specifically designed for HackRF One to eliminates EMI nearby. Comes with: RF shield, shield frame, shield cover, GND clip testpoint, J10, and a 20

    12,11 € tax incl.

    10,09 €tax excl.

    In stock
  • Aluminium case HackRF One - Nooelec

    Nooelec aluminium case V2 (new version) specifically designed for HackRF One reduce parasitic interference nearby and add a stronger resistant case. This aluminum case is for replacing the original

    37,90 € tax incl.

    31,58 €tax excl.

    In stock
  • Broadcast FM Band Cut filter by RTL-SDR.com

    This band-cut filter is design by RTL-SDR.com, it blocks and reject broadcast FM band between 88 to 108 MHz with over 50dB of attenuation. Insertion loss is less than 0.5 dB between 0-1 GHz, and less

    23,00 € tax incl.

    19,17 €tax excl.

    In stock
  • BIAS-TEE for QO-100 or LNA 30MHz to 4GHz F1OPA

    This BT4G-based BIAS-TEE with SMA female connector is used to power a LNA or a 10Ghz PLL LNB to receive the QO-100 / Es'Hail2 satellite.The BT4G covers the frequency bands from 30 MHz to 4 GHz. The

    17,50 € tax incl.

    14,58 €tax excl.

    In stock
  • LNA Wide Band 50-4000Mhz RTL-SDR

    This wide-band LNA preamp improves reception performance from 50 Mhz to 4 Ghz, it is based on SPF5189Z, with a noise factor of less than 1 dB.This LNA is designed to be powered by BIAS-T with a power

    26,78 € tax incl.

    22,32 €tax excl.

    In stock
  • LNA Wide Band 50-2500Mhz amplifier F1OPA

    Wide-band LNA preamp, based on PGA-103+, to improve reception performance from 50 Mhz to 1500 Mhz, with a maximum gain of 20-24dB and a noise factor of 0.4dB.This VHF-UHF LNA offers a very good

    37,80 € tax incl.

    31,50 €tax excl.

    Out of stock, available in 2 to 3 weeks
  • 2.4 Ghz SAW Bandpass filter for QO100

    This bandpass filter for the 2.4 Ghz (13cm) allows to reject the local oscillator and harmonics frequencies of the Up-Converter for QO-100 to get a clean signal on the satellite, with a max. input

    26,90 € tax incl.

    22,42 €tax excl.

    In stock
  • Bandpass SAW Filter 868 Mhz for Helium LoRa Meshtastic Lorawan SigFox Zigbee

    This filter for the 868 MHz bandpass allows to improve the selectivity of the reception and to suppress the parasitic signals outside the 868MHz band and in particular to reject the GSM 900 MHz

    27,90 € tax incl.

    23,25 €tax excl.

    Out of stock, available in 1 month
  • LNA preamp 50-4000 Mhz with SPF5189Z

    This SPF5189Z LNA preamp improves reception performance from 50 Mhz to 4000 Mhz, based on SPF5189Z, with a noise factor of 0.6 dB and a maximum gain of approximately 20dB.This low noise amplifier is

    8,90 € tax incl.

    7,42 €tax excl.

    In stock
  • Nooelec LaNA LNA preamp 20MHz - 4GHz + case + USB DC Bias-T

    Nooelec's LANA is a high-gain, 20 MHz - 4 GHz wide band LNA amplifier for SDR applications, with low power consumption and better linearity than the SPF5189Z LNA.The LaNa has 3 different power

    35,90 € tax incl.

    29,92 €tax excl.

    In stock
  • 137 Mhz filter Double LNA & SAW Nooelec for NOAA

    This SawBird + filter from Nooelec is specially designed to operate on the NOAA 137 Mhz frequency band and for NOAA weather satellite reception applications.It makes it possible to significantly

    57,05 € tax incl.

    47,54 €tax excl.

    In stock
  • BIAS-Tee RF power supply module for QO100 and LNA LNB heads

    This BIAS-TEE module can be used to power an RF accessory such as an LNA preamp preamplifier or a LNB PLL 10Ghz to receive QO100. Power is supplied via an external DC power supply (30V max.) by

    8,50 € tax incl.

    7,08 €tax excl.

    In stock
  • Opera Cake 8 port automatic antenna switch for HackRF One

    Opera Cake is an additional antenna switch card for the HackRF One SDR development board.This antenna switch can be configured with command line software for automatic port switching based on

    199,00 € tax incl.

    165,84 €tax excl.

    209,00 €
    Out of stock, available within 1-2 months
  • Nooelec VeGA variable gain amplifier LNA module Barebones 30MHz-4000MHz

    The VeGA Barebones is a 30MHz to 4000MHz broadband linear LNA module designed to allow the user to control the level of amplification to achieve the best signal-to-noise ratio (SNR). The device can be

    85,61 € tax incl.

    71,34 €tax excl.

    In stock

Delivery Europe & Overseas

Stock and shipped from France

Product return

14 days to return, 2 warranty

Email support

Response within 24h to 72h

Secure payment

SSL, VISA, Mastercard, Paypal

Copyright 2014-2024 - Passion Radio / 4 MY PEOPLE.
Les photos et coloris ne sont pas contractuels.