No products
New products
-
2.4GHz TX 2.5W Max Bidirectional Amplifier + 10dB RX Preamp
259,00 € tax excl. -
-
Switching power supply MOONRAKER SM-30II 30A
99,00 € tax excl. -
USB CAT & PTT Control Interface Digirig DR-891 for YAESU FT-891
99,00 € tax excl.
Viewed products
-
Clear Acrylic Case for...
Great Scott Gadgets official case, transparent...
-
AlexTune RF tuning indicator for QRP 20W magnetic loop antenna
36,67 € -20% 45,83 €
No review at the momentData sheet
Assembly Instructions
Warning: Do not overtighten! Hand-tighten only at every step.
1 - Use the guitar pick supplied to extract the HackRF One circuit board from the black plastic case.
2 - Insert one long screw into each corner of the bottom acrylic panel. Secure each long screw with a short (5 mm) spacer on the opposite side of the panel.
3 - Place the HackRF One circuit board (facing up) on top of the bottom panel, fitting the ends of the long screws through the corner mounting holes of the circuit board.
4 - Secure the circuit board with one long (6 mm) spacer in each corner.
5 - Place the top acrylic panel on top of the circuit board, aligning the cutouts with the circuit board's expansion headers.
6 - Secure each corner with a short screw.
Customers also bought
Reference: GSG-OPERA-CAKE-1757
Opera Cake 8 port automatic antenna switch for HackRF One
Opera Cake is an additional antenna switch card for the HackRF One SDR development board.This antenna switch can be configured with command line software for automatic port switching based on
199,00 €209,00 €
We also recommend
75,00 €Reference: NOO-100721-HAM-IT-UP-PLUS-441
Ham it Up 1.3 & 1.3+ Converter HF 0.5-50Mhz Nooelec
Nooelec's Ham It Up v1.3 is an up-converter HF, equipped with the 125Mhz filter soldered on the PCB and allows to listen to all MF / HF bands from 0.5 to 50 Mhz, in all modes of modulation, from a
75,00 €Online only
34,90 €Reference: GSG-HACKRF-ANT500-74
ANT500 SDR ADSB antenna 75-1000Mhz SMA-M
Telescopic antenna ANT500, VHF-UHF 50 ohms designed to operate in RX from 75 MHz to 1 GHz. Configurable length of 20 cm to 88 cm. Stainless steel SMA male connector and elbow swivel 360 °. This is an
34,90 €Online only
32,90 €Reference: DIAMOND-SRH789-259
Diamond antenna SRH-789 SMA-M 95-1100Mz + TX 144/430Mhz
Dual band directional antenna Original Diamond SRH-789 with SMA Male connector, for receiving and transmitting on VHF-UHF bands (144/430 MHz) and reception on aviation bands 120/150/300/450/800 MHz
32,90 €
12,11 €Reference: NOO-SHIED-HACK-BLANC-100624-313
Nooelec RF Shield Kit for HackRF One
This RF shield Nooelec and component kit is specifically designed for HackRF One to eliminates EMI nearby. Comes with: RF shield, shield frame, shield cover, GND clip testpoint, J10, and a 20
12,11 €Online only
Reviews
Additional or similar equipment
-
Ham it Up 1.3 & 1.3+ Converter HF 0.5-50Mhz Nooelec
Nooelec's Ham It Up v1.3 is an up-converter HF, equipped with the 125Mhz filter soldered on the PCB and allows to listen to all MF / HF bands from 0.5 to 50 Mhz, in all modes of modulation, from a
75,00 € tax incl.Product available with different options62,50 €tax excl.
-
ANT500 SDR ADSB antenna 75-1000Mhz SMA-M
Telescopic antenna ANT500, VHF-UHF 50 ohms designed to operate in RX from 75 MHz to 1 GHz. Configurable length of 20 cm to 88 cm. Stainless steel SMA male connector and elbow swivel 360 °. This is an
34,90 € tax incl.In stock29,08 €tax excl.
-
Diamond antenna SRH-789 SMA-M 95-1100Mz + TX 144/430Mhz
Dual band directional antenna Original Diamond SRH-789 with SMA Male connector, for receiving and transmitting on VHF-UHF bands (144/430 MHz) and reception on aviation bands 120/150/300/450/800 MHz
32,90 € tax incl.In stock27,42 €tax excl.
LNA VHF UHF preamplifier with PGA-103 + for RF and SDR application
The LNA4ALL is a pre-amplifier and a low-pass filter (LNA) with SMA female RF connectors and for RF frequencies covering all bands from 28MHZ to 2500 MHz. It improves greatly reception performance, on
44,90 € tax incl.In stock37,42 €tax excl.
USB VFO jog Shuttle Xpress Contour Design for SDR
Allows to control by USB the change of frequencies of an SDR software and to get a classic operation of a VFO on a radio hardware SDR!Fully configurable with the supplied software, Shuttle Xpress is
-
Nooelec RF Shield Kit for HackRF One
This RF shield Nooelec and component kit is specifically designed for HackRF One to eliminates EMI nearby. Comes with: RF shield, shield frame, shield cover, GND clip testpoint, J10, and a 20
12,11 € tax incl.In stock10,09 €tax excl.
Aluminium case HackRF One - Nooelec
Nooelec aluminium case V2 (new version) specifically designed for HackRF One reduce parasitic interference nearby and add a stronger resistant case. This aluminum case is for replacing the original
37,90 € tax incl.In stock31,58 €tax excl.
Antenna ANT700 300-1100Mhz SDR VHF UHF ADSB
Telescopic Antenna ANT700 from 300 to 1100 MHz, made by Great Scott Gadgets. The total length of the antenna ANT700 is configurable from 9.5 cm to 24.5 cm. The ANT700 is constructed of stainless
28,90 € tax incl.In stock24,08 €tax excl.
Opera Cake 8 port automatic antenna switch for HackRF One
Opera Cake is an additional antenna switch card for the HackRF One SDR development board.This antenna switch can be configured with command line software for automatic port switching based on
199,00 € tax incl.Out of stock, available within 1-2 months165,84 €tax excl.
209,00 €
Delivery Europe & Overseas
Stock and shipped from France
Product return
14 days to return, 2 warranty
Email support
Response within 24h to 72h
Secure payment
SSL, VISA, Mastercard, Paypal
Copyright 2014-2024 - Passion Radio / 4 MY PEOPLE.
Les photos et coloris ne sont pas contractuels.