No products
New products
-
LILYGO T-BEAM SUPREME SX1262 433 MHz Meshtastic LoRa WiFi BT5 GPS
55,78 € tax excl. -
TTGO T-BEAM SUPREME SX1262 Meshtastic 868 MHz Lora WiFi BT5 GPS
55,78 € tax excl. -
Diamond HVC14CX 20m & 30m coil for HV7CX antenna
27,40 € tax excl. -
Diamond HV7CX multiband mobile HF VHF & UHF antenna
152,78 € tax excl.
-
6mm plastic radio screws (pair)
0,81 € -3% 0,83 €
-3%
View larger 
Diamond CMF-2000 common mode filter TVI RF choke
No review at the momentThe Diamond CMF-2000 is a common mode filter that will prevent TVI and EMI CEM interference, caused by the transmission coaxial cable.
Usable from 1 to 54 Mhz all bands, HF amateur radio, CB 27 Mhz, 50Mhz (6m) with a maximum admissible power of 2000W.
Connects to the transmission line via female UHF connectors (SO-239) and act like a RF choke line isolator.
This low pass filter eliminates harmonic frequencies outside the 1-54Mhz band.
Comes with: 1 Diamond CMF-2000, original warranty.
Data sheet
CMF2000 RF choke filter specifications
Frequency: 1 MHz to 54 MHz
Maximum input power: 2000W (SSB)
Common mode attenuation: -50dB or more
Insertion loss: less than 0.2dB
Impedance: 50Ω
VSWR: Less than 1.2
Connector: UHF female (SO-239)
Total length: 380 mm
Weight: 650g
Customers also bought
5,75 €Reference: ADAPT-UHF-M-UHF-M-293
UHF Male adapter
RF adapter for UHF Male to UHF Male connector (PL-259). Impedance 50 ohms.
5,75 €
6,58 €Reference: ADAPT-UHF-M-COUDE-UHF-F-450
UHF Male to UHF Female angled adapter
Angled RF adapter with UHF Male (PL-259) to UHF Female (SO-239) connector. Impedance 50 ohms.
6,58 €6,58 €
4,06 €Reference: MESSI-SILICSEAL-S-1824
M&P Self-tightening silicone seal for connector and coaxial cable
Self-tightening silicone rubber tubular seal for 7.3mm (.287") or 10.3mm (.400") or 12.7mm (.500") Ø cables, suitable for all Messi and Paoloni connectors and adaptors (except 7/16 and right angle
4,06 €
7,42 €Reference: PIGTAIL-SMA-M-N-F-79
Pigtail SMA Male - N Female 15/50/100cm RG316
SMA Male to N Female pigtail adapter. RG 316 50 ohm coaxial cable. Available in 15cm, 50cm or 1 metre lengths (choose below).
7,42 €
We also recommend
25,80 € 26,60 € tax excl. -3%tax excl. In stock-3%
Reference: NOOELEC-100722-OUTERNET-467
LNA & SAW filter for Inmarsat and Outernet
This LNA and SAW filter from Nooelec is specially designed to operate on 1.5Ghz Outernet frequency band and for Inmarsat radio applications, covering from 1.50GHz to 1.58GHz. It significantly
25,80 €26,60 €
Reduced price!
18,59 € 19,17 € tax excl. -3%tax excl. In stock-3%
Reference: FILTRE-RTLSDR-FM-473
Broadcast FM Band Cut filter by RTL-SDR.com
This band-cut filter is design by RTL-SDR.com, it blocks and reject broadcast FM band between 88 to 108 MHz with over 50dB of attenuation. Insertion loss is less than 0.5 dB between 0-1 GHz, and less
18,59 €19,17 €
Reduced price!
18,59 € 19,17 € tax excl. -3%tax excl. In stock-3%
Reference: FILTRE-RTLSDR-523
Broadcast AM Band Cut filter by RTL-SDR.com
This high-pass notch filter is designed by RTL-SDR.com and rejects the AM broadcast from 500 kHz to 1.7 MHz, with attenuation of more than 50dB. In fact, because of the attenuation, the filter is
18,59 €19,17 €
Reduced price!
25,99 € 26,79 € tax excl. -3%tax excl. Out of stock, available in 2 to 3 months-3%
Reference: DIAMOND-MAT50-625
Ground plane for magnetic mount & HF antenna Diamond MAT50
To use an HF antenna below 50Mhz band, a ground plane are required. This is not always possible or easy especially for antennas with magnetic base or for installations on a balcony. Diamond MAT-50
25,99 €26,79 €
Reduced price!
Reviews
Additional or similar equipment
-
LNA & SAW filter for Inmarsat and Outernet
This LNA and SAW filter from Nooelec is specially designed to operate on 1.5Ghz Outernet frequency band and for Inmarsat radio applications, covering from 1.50GHz to 1.58GHz. It significantly
25,80 € tax incl.In stock25,80 €tax excl.
26,60 € -3% -
Broadcast FM Band Cut filter by RTL-SDR.com
This band-cut filter is design by RTL-SDR.com, it blocks and reject broadcast FM band between 88 to 108 MHz with over 50dB of attenuation. Insertion loss is less than 0.5 dB between 0-1 GHz, and less
18,59 € tax incl.In stock18,59 €tax excl.
19,17 € -3% -
Broadcast AM Band Cut filter by RTL-SDR.com
This high-pass notch filter is designed by RTL-SDR.com and rejects the AM broadcast from 500 kHz to 1.7 MHz, with attenuation of more than 50dB. In fact, because of the attenuation, the filter is
18,59 € tax incl.In stock18,59 €tax excl.
19,17 € -3% -
Ground plane for magnetic mount & HF antenna Diamond MAT50
To use an HF antenna below 50Mhz band, a ground plane are required. This is not always possible or easy especially for antennas with magnetic base or for installations on a balcony. Diamond MAT-50
25,99 € tax incl.Out of stock, available in 2 to 3 months25,99 €tax excl.
26,79 € -3% 
1090 Mhz SAW Bandpass ADS-B filter F1OPA
This ADS-B bandpass/cut filter for 1090Mhz allows to improve the performance and the selectivity of the signal in ADS-B reception and to suppress the signals outside the 1090Mhz band.Delivered with :
23,25 € tax incl.In stock23,25 €tax excl.
2.4 Ghz SAW Bandpass filter for QO100
This bandpass filter for the 2.4 Ghz (13cm) allows to reject the local oscillator and harmonics frequencies of the Up-Converter for QO-100 to get a clean signal on the satellite, with a max. input
22,42 € tax incl.In stock22,42 €tax excl.
Bandpass SAW Filter 868 Mhz for Helium LoRa Lorawan SigFox
This filter for the 868 MHz bandpass allows to improve the selectivity of the reception and to suppress the parasitic signals outside the 868MHz band and in particular to reject the GSM 900 MHz
23,25 € tax incl.In stock23,25 €tax excl.
TAOGLAS RF Filter Bandpass 2.4Ghz 10W WiFi and QO-100 - BPF.24.01
The Taoglas Airvu 2.4Ghz bandpass filter is a 100Mhz broadband filter, for use in frequency from 2400 to 2500Mhz and a maximum power of 10W.Connector 1: RP-SMA MaleConnector 2: RP-SMA Female Note: The
12,04 € tax incl.Out of stock, available in 1-2 weeks12,04 €tax excl.
24,08 € -50%
Bandpass filter 1090 Mhz ADS-B AirNav RadarBox
This 1090 Mhz ADS-B bandpass / band-stop filter to improve ADS-B reception performance and suppress parasitic signals outside the 1090Mhz band. With SMA male and SMA female connector. Compatible with
137 Mhz filter Double LNA & SAW Nooelec for NOAA
This SawBird + filter from Nooelec is specially designed to operate on the NOAA 137 Mhz frequency band and for NOAA weather satellite reception applications.It makes it possible to significantly
46,12 € tax incl.In stock46,12 €tax excl.
47,54 € -3%
Delivery Europe & Overseas
Stock and shipped from France
Product return
14 days to return, 2 warranty
Email support
Response within 24h to 72h
Secure payment
SSL, VISA, Mastercard, Paypal
Copyright 2014-2024 - Passion Radio / 4 MY PEOPLE.
Les photos et coloris ne sont pas contractuels.