Viewed products
88 - 108MHz Band Stop Filter High Performance...
88 - 108MHz Band Stop Filter High Performance Band Stop Broadcast FM reject Filter with SMA Female Connector
- Blocks the broadcast FM band between 88 - 108 MHz with over 50dB of attenuation. It is designed for maximum attenuation between 88 and 108 MHz and 3dB roll-off points are at 76 MHz and 122 MHz.
- Insertion loss is less than 0.5 dB between 0 and 1 GHz. and generally less than 1.5 dB between 1 and 3 GHz.
- It uses SMA female connectors.
Note:
- RX filter only. Designed for SDR users, it can also be useful for TV users experiencing FM interference. However, TV users are advised to check spectrum analyser graphs and 3 dB attenuation points carefully to ensure that the filter will not block a TV signal of interest. For example, channels between 76 and 88 MHz could be attenuated enough to lose reception.
Included in the package:
- 1 x bandstop filter
- 1 x SMA male to SMA male adaptor
Reference: PIGTAIL-SMA-M-UHF-F-80
Adapter cable pigtail SMA Male to plug UHF Female. RG 316 50 ohm coaxial cable. Available in 3 lengths: 15, 50 and 100 cm.
Reference: ADAPT-SMA-M-SMA-M-291
This RF adapter is fitted with a male SMA connector on both sides. It can be used to connect 2 SMA female cables or connectors, for example.
Reference: CLE-RTLSDR-V3-472
This USB stick is the optimized V3 version of RTL-SDR.com, with the R860 tuner chip (exactly the same as R820T2*) for reception from 24 to 1766 MHz. The characteristics of the dongle RTL-SDR.com v3:-
Reference: RFKONNECT-PCB-ATTENUATEUR-1011
This PCB-based RF attenuator module reduces the power of a radio signal by -10 to -30dB, with a maximum input power of 23dBm (200Mw), with female SMA connector, for use from 0 to 4000Mhz (4Ghz).
8,90 €
Reference: PIGTAIL-SMA-M-SMA-M-81
SMA Male to SMA Male pigtail adapter, for connecting a card, for example converter Ham it upconverter card to the SDR transceiver HackRF One SDR transceiver, or the SDRPlay broadband receiverwideband
Reference: ADAPT-SMA-M-SMA-M-291
This RF adapter is fitted with a male SMA connector on both sides. It can be used to connect 2 SMA female cables or connectors, for example.
Reference: FILTRE-RTLSDR-FM-473
This band-cut filter is design by RTL-SDR.com, it blocks and reject broadcast FM band between 88 to 108 MHz with over 50dB of attenuation. Insertion loss is less than 0.5 dB between 0-1 GHz, and less
Reference: FILTRE-RTLSDR-523
This high-pass notch filter is designed by RTL-SDR.com and rejects the AM broadcast from 500 kHz to 1.7 MHz, with attenuation of more than 50dB. In fact, because of the attenuation, the filter is
Click here to leave a review
Be the first to ask a question about this product!
SMA Male to SMA Male pigtail adapter, for connecting a card, for example converter Ham it upconverter card to the SDR transceiver HackRF One SDR transceiver, or the SDRPlay broadband receiverwideband
4,17 €tax excl.
This RF adapter is fitted with a male SMA connector on both sides. It can be used to connect 2 SMA female cables or connectors, for example.
3,75 €tax excl.
This band-cut filter is design by RTL-SDR.com, it blocks and reject broadcast FM band between 88 to 108 MHz with over 50dB of attenuation. Insertion loss is less than 0.5 dB between 0-1 GHz, and less
19,17 €tax excl.
This high-pass notch filter is designed by RTL-SDR.com and rejects the AM broadcast from 500 kHz to 1.7 MHz, with attenuation of more than 50dB. In fact, because of the attenuation, the filter is
19,17 €tax excl.
Stock and shipped from France
14 days to return, 2 warranty
Response within 24h to 72h
SSL, VISA, Mastercard, Paypal
Copyright 2014-2024 - Passion Radio / 4 MY PEOPLE.
Les photos et coloris ne sont pas contractuels.